Roll roofing is a popular, budget-friendly option for many homeowners, especially in areas like Glens Falls, NY, where Benson Contracting offers expert installation services. This guide provides a detailed walkthrough for installing roll roofing, ensuring a durable and aesthetically pleasing outcome.
Understanding Roll Roofing
Roll roofing, a lightweight and versatile material, is ideal for low-slope roofs. It’s available in various colors and types, each requiring specific installation techniques. Whether using self-adhesive or nail-down methods, proper installation is key to longevity.
Necessary Tools and Materials
To successfully install roll roofing, you’ll need:
- Roll Roofing
- Ladder
- Roofing Nails
- Roofing Cement
- Measuring Tape
- Roofing Felt or Primer
- Utility Knife
- Screwdriver
- Chalk Line
- Broom
- Flat Pry Bar
Installation Steps
1. Roof Measurement
Accurately measure your roof to determine the amount of roll roofing required. Measure each section separately for sectionalized roofs, then add these areas together for the total roof area.
2. Material Acquisition
Purchase sufficient roll roofing based on your measurements, including extra for overhangs and overlaps.
3. Roof Preparation
Clean the roof surface thoroughly, removing all debris, dirt, and loose nails. Ensure the sheathing is smooth and even.
4. Underlay Installation
Though optional, installing an underlay adds an extra protection layer. Cut and attach the underlay with nails, ensuring it’s flat and straight.
5. Drafting the First Layer
Mark 15 inches from the bottom edge of the roof sheathing at several points using chalk.
6. Applying Roofing Cement
Spread roofing cement along the roof edges, about 1⁄8-1⁄4 inch thick, using a trowel.
7. Cutting Roll Roofing
Cut the roll roofing to size, allowing for a one-inch overhang on the eaves. Ensure it reaches each chalk line.
8. Laying the First Layer
Position the first roll roofing layer to cover the roof down to the chalk line, stretching it to avoid wrinkles.
9. Securing with Nails
Use a hammer to drive 1-inch roofing nails into the roll roofing, ensuring they are flush with the material.
10. Second Layer Mapping
Measure and mark 32 inches above the first layer with tape and chalk.
11. Second Layer Application
Spread roofing cement and carefully place the first 6 inches of the second layer over the first.
12. Nailing the Second Layer
Nail down the second layer, ensuring it’s flat and even, and secure it to the first layer.
13. Cementing the Nails
Cover all nails with roofing cement for added protection.
14. Trimming and Sealing
Trim any excess roll roofing and seal the edges with cement.
15. Final Cleanup
Remove any remaining debris or materials from the roof.
Conclusion
While these steps provide a clear path to installing roll roofing, the process can be challenging and risky. For professional installation in Glens Falls, NY, consider Benson Contracting, ensuring a safe and high-quality roofing solution.
continue reading
